Siemens SINUMERIK 802D sl Manual de servicio descargar pdf (Pagina 26)

Setting-up

4.2 Limit stops

Manual Machine Plus Turning

26 Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

4.2 Limit stops

Functionality

Limit stops are used to stop the axes in a specific position.

If an axis stops in the limit stop position, it cannot be moved again until the triggering limit

stop is reset.

By setting the limit stops, in the "Manual Machine Plus" operating area, it is possible to turn

simple shoulders (including tapers) without the need for any further cycle parameterization.

Supplementary conditions

● The limit stop position is always an absolute dimension, which in turn always corresponds

to the position in the absolute actual value display on the "Manual Machine Plus"

interface. A relative limit stop position is not possible.

● A limit stop position can be entered/accepted only when the axes are stationary.

Otherwise, an error message appears.

4.2.1 Setting and activating/deactivating limit stops

Functionality

In the main screen "Manual Machine Plus" limit stops can be entered into the input fields "-

X/-Z/+X/+Z".

In the following screen, the cursor (the field has a dark background) is located in the input

field "Endstop of axis X+".

Figure 4-3 Endstop of axis X+

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 129 130

Sin comentarios

Siemens SINUMERIK 802D sl Manual de servicio Pagina 26