Siemens SINUMERIK 802D sl Manual de servicio descargar pdf (Pagina 24)

Setting-up

4.1 Measuring tools

Manual Machine Plus Turning

24 Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

Operating sequences

Proceed as follows to measure the tool for the X axis of the loaded turning tool.

1. Press the "Meas. tool" softkey. The following screen appears:

Figure 4-1 Measure a turning tool

2. Press the "X" softkey.

The screen for measuring the X axis (L1) appears.

3. Check that the current tool number appears in the display field for the tool, since the

calibration operation will relate to this tool.

4. Carefully "scratch" a workpiece by an X handwheel infeed when the spindle is turning.

5. Move the slide slightly (without changing the X position) along the Z axis (longitudinal

turning) with the handwheel.

6. Switch the spindle off.

7. Enter the diameter measured on the workpiece in entry field "d1".

8. Accept the value by pressing the <INPUT> key.

The controller then automatically calculates the corresponding tool offset (in the radius)

and displays this as value "L1" in the screen form.

CAUTION

If you exit the screen form at this point, the new offset will not take effect.

0HDV

WRRO

;

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 129 130

Sin comentarios

Siemens SINUMERIK 802D sl Manual de servicio Pagina 24