Siemens SINUMERIK 802D sl Manual de servicio descargar pdf (Pagina 36)

Manual machining

5.2 Display and operator control optios in the main screen for "Manual Machine Plus"

Manual Machine Plus Turning

36 Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

Displayed values Meaning

• Feed stop as a result of:

– Feedrate override at position 0%.

– An alarm is active which prevents the axes from moving.

• Spindle status

– Spindle counter-clockwise

– Spindle stop

– Spindle clockwise

Machining and technology data

You must enter the machining technology data in the following input fields:

Figure 5-3 Display box from main screen "Manual Machine Plus", entry of machining technology

data

The machining technology data are as follows:

Parameter Description

T Tool number of the used tool (only for use of a manual tool-changer system)

F Feedrate with choice of units mm/min (time feed) and mm/rev (revolutional feed),

S Spindle type with choice of units rev/min (constant spindle speed) and m/min

(constant cutting rate),

MR Speed limitation for constant cutting rate

-X

-Z

Positions of the limit stops, the limit stops can be activated using the toggle field

"ON/OFF"

CAUTION

Generally speaking, the relevant machining technology data must be entered before

starting manual machining.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 129 130

Sin comentarios

Siemens SINUMERIK 802D sl Manual de servicio Pagina 36