Siemens SINUMERIK 802D sl Manual de servicio descargar pdf (Pagina 17)

Manual Machine Plus Turning

Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

Turning On, Reference Point Approach

3.1 Entry to the "Manual Machine Plus" operating area

Operating sequences

Note

The operating area "Manual Machine Plus" runs only in Siemens mode, and not in ISO

mode.

Proceed as follows to open the "Manual Machine Plus" application:

Note

If the controller has already been preconfigured to "Manual Machine Plus" by the machine

manufacturer, items 1 to 3 can be ignored in the following description. The operating area

"Manual Machine Plus" is activated once the controller has been started up.

If you have not yet executed a reference point approach, you will be in the operating mode

Reference point approach (see Fig. Reference point approach) after start-up.

1. The NC boots into the JOG REF operating mode of the NC basic machine.

2. Select the JOG operating mode.

The interface can be seen in the screenshot below:

Figure 3-1 "Position" operating area

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 129 130

Sin comentarios

Siemens SINUMERIK 802D sl Manual de servicio Pagina 17