Siemens SINUMERIK 802D sl Manual de servicio descargar pdf (Pagina 56)

Manual machining

5.4 Manual machining using cycles (functions)

Manual Machine Plus Turning

56 Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

This softkey takes you back to the main screen.

If you have edited any values, the following prompt window appears:

Figure 5-19 Cycles prompt text

Your inputs are accepted when you press the "OK" softkey.

Your inputs are discarded when you press the "Abort" softkey.

3. The function was parameterized (e.g. thread tapping).

Activate the function using the "OK" softkey.

The following execute screen appears:

Figure 5-20 Example of executing a machining operation

The current machining status is displayed in the center of the execute screen. This status

could be one of the following:

– Machining not started

– Machining active

– Machining aborted

– Machining interrupted

– Machining finished

In the example, the text "Machining not started" is displayed.

4. Start machining using the <NC-Start> key.

The machining operation on the workpiece is executed.

;

$ERUW

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 129 130

Sin comentarios

Siemens SINUMERIK 802D sl Manual de servicio Pagina 56