Siemens SINUMERIK 802D sl Manual de servicio descargar pdf (Pagina 48)

Manual machining

5.3 Manual machining with machining types

Manual Machine Plus Turning

48 Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

5.3.2 Manual taper turning

Functionality

The "Manual taper turning" function is intended for the simple production of tapered

workpieces.

For the machining type "Taper turning" you need to enter an angle (taper angle α). The angle

input rotates the controller’s internal coordinate system according to the angle value.

When you move the axis direction switch, the controller then uses the angle input to

interpolate (and simultaneously traverses) the X and Z axes accordingly.

The programmed axis feed then applies to the path being traversed and not to the

corresponding axis.

If tapers with defined end points are to be turned, the use of limit stops is a helpful addition to

this function.

NOTICE

The desired taper is traversed only by means of an axis direction switch or axis direction

keys of the machine control panel depending on the machine equipment.

A traversal using the handwheels is not possible!

Operating sequences

1. You can access the "Manual taper turning" function in the main screen for "Manual

Machine Plus".

2. Press the "Machining mode" softkey until "Taper turning" is displayed.

Figure 5-12 Taper turning

0DFKLQHG

W\SH

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 129 130

Sin comentarios

Siemens SINUMERIK 802D sl Manual de servicio Pagina 48