Siemens SINUMERIK 802D sl Manual de servicio descargar pdf (Pagina 68)

Manual machining

5.4 Manual machining using cycles (functions)

Manual Machine Plus Turning

68 Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

5.4.5.2 Groove cycle - multiple

Functionality

Note

The "Multiple groove" function supplements the "Single groove" option. This function can be

used only if all the parameters for the "Groove cycle - single" function have been assigned!

As soon as you position the cursor in any of the input fields in the multiple grooves area of

the screen, the display changes from single groove to multiple grooves:

Figure 5-29 Groove cycle - multiple

Parameter

Parameter Description

Distance l3 Groove offset in the longitudinal axis (Z axis): This input value determines the offset

between several identical grooves during production. The direction of the groove offset

between the individual grooves is always towards the chuck.

Number n Number of grooves to be produced. Entering "0" or "1" here has the same effect: A single

groove is produced. When you enter a value of ">1", the appropriate number of grooves is

machined. The input value in parameter "Length I3" defines the necessary offset.

DANGER

Notice:When you are machining multiple grooves, make sure that there is sufficient

clearance from the spindle as measured from starting position "Reference z0" to allow all

parameterized grooves to be machined. There is otherwise a risk of collision between the

tool and the chuck!

-> Check the plausibility of the input values before pressing NC start!

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 129 130

Sin comentarios

Siemens SINUMERIK 802D sl Manual de servicio Pagina 68