Siemens Sinumerik 810T Manual de usuario descargar pdf (Pagina 84)

EMCO WINNC SINUMERIK 810/820 T ALARMS / MESSAGES

H 8

8187 PLC program error

see 8175.

8188 Gear command invalid

see 8175.

8189 Invalid channel assignement

see 8175.

8190 Invalid channel within message

8191 Invalid jog feed unit

8192 Invalid axis in command

8193 Fatal PLC error

see 8175.

8194 Thread without length

8195 No thread slope in leading axis

Remedy: Program thread pitch

8196 Too manny axis for thread

Remedy: Program max. 2 axes for thread.

8197 Thread not long enough

Cause: Thread length too short.

With transition from one thread to the other

the length of the second thread must be

sufficient to produce a correct thread.

Remedy: Longer second thread or replace it by a

linear interpolation (G1).

8198 Internal error (to manny threads)

see 8175.

8199 Internal error (thread state)

Cause: Internal error

Remedy: Restart software or reinstall when neces-

sary, report to EMCO, if repeatable.

8200 Thread without spindle on

Remedy: Switch on spindle

8201 Internal thread error (IPO)

see 8199.

8201 Internal thread error (IPO)

see 8199.

8203 Fatal AC error (0-ptr IPO)

see 8199.

8204 Fatal init error: PLC/IPO running

see 8199.

8205 PLC Runtime exceeded

Cause: Insufficient computer performance

8206 Invalid PLC M-group initialisation

see 8199.

8207 Invalid PLC machine data

see 8199.

8208 Invalid application message

see 8199.

8211 Feed too high (thread)

Cause: Thread pitch too large / missing, Feed for

thread reaches 80% of rapid feed

Remedy: Program correction, lower pitch or lower

spindle speed for thread

9001 unknown parameter !

Cause: SPS diagnosis, unknown parameter

entered

9002 Par.-number not allowed !

Cause: SPS diagnosis, unknown parameter

number entered

9003 unknown display-format !

SPS-diagnosis

9004 DB not existant !

SPS-diagnosis

9005 DW not existant !

SPS-diagnosis

9006 Invalid COM-port !

SPS-diagnosis

9007 Data-transmition activ !

data I/O

9011 No files found !

data I/O

9014 File already exists !

data I/O

9015 Error while opening file !

data I/O

9016 Error while reading file !

data I/O: error while opening a file

9017 Error while writing file !

data I/O: error while writing a file

9018 Invalid COM configuration !

data I/O

9019 No digitizer initial data foand !

Cause: a digitizer was set, but not calibrated

Remedy: calibrate digitizer (set edge points), see

"External Input Devices"

9020 No valid input !

Cause: digitizer was activated on invalied field

9021 COM-port is already used !

Cause: Another device is already connected to this

COM port.

9022 Digitizer not connected

Remedy: Connect digitizer, switch on ...

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 90

Comentarios a estos manuales

Sin comentarios