Siemens Sinumerik 810T Manual de usuario descargar pdf (Pagina 47)

EMCO WINNC SINUMERIK 810/820 T

D 15

PROGRAMMING

G 92 Cylindrical interpolation

Format

N... G92 P.. C

G92 P.. ...... Cylindrical interpolation ON

G92 P1 ...... Cylindrical interpolation OFF

P ................. Factor for unit circle

C................. Axis name for rotary axis

Cylindrical interpolation permits machining of cylin-

drical paths with one rotary axis and one linear axis.

Both linear and circular contours may be programmed.

It is not possible to input the interpolation parameters

I, J and K.

The position of the rotary axis is entered in degrees.

The ration is programmed under G92 P... for this

purpose.

The control forms the ration from the machining

diameter and the unit diameter as follows:

machining diameter

unit diameter

Unit diameter =

360

in mm or inch

The unit diameter is derived from the ralation

p x π = 360 ab

No characters other than axis name must be written

in a block containing G92P...

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 89 90

Sin comentarios

Siemens Sinumerik 810T Manual de usuario Pagina 47