
Installation
3-5
TIWAY 1 Ti505 NIM User Manual
3.3 SETTING
THE DIPSWITCHES
As
Figure 1 illustrates, there are two blocks of dipswitches on the TI505 NIM. The block
of
eight switches is the NIM Network Address
Selection switch. The block of ten switches
is
the Network Configuration Parameters switch. Note that the switches are numbered
from
left to right (when the switches are facing you). When setting
up your NIM, use the
configuration
data sheet in Appendix B of this manual to record important configuration
information.
NOTE
The configuration and address switch settings are read only
once
following a power
-up or reset. Be sure to reset the NIM fol
-
lowing
any change in dipswitch settings or P/C memory reconfi
-
guration.
Network Configuration Parameters
Network
Address Selection
Figure 1
NIM Dipswitches
Comentarios a estos manuales