Siemens SIMATIC TIWAY 1 Manual de usuario descargar pdf (Pagina 41)

Installation

3-4

TIWAY 1 TI505 NIM User Manual

3.2 INSTALLING THE NIM

To place a NIM into your TI505 system, you have to select the NIM communication

parameters,

install the NIM in the TI505 I/O base, connect the communication cables to

the NIM, and initialize the system for operation. The Programmable Controller (P/C)

and

the programming device should be in place before you install a NIM.

WARNING

Do not insert or remove the NIM while power is applied

the P/C system, since doing this may cause personal in

jury,

alter P/C memory

, cause a

P/C fatal error

, or damage

the

module.

The

following steps summarize the NIM installation.

Disconnect power to the P/C system (I/O base, power supply

, etc.).

Set the configuration dipswitches and LOCAL/REMOTE switch.

Insert the module into the base and secure it with the bezel screws.

Power up the P/C system.

5. Use

the NIM diagnostics and LED status indicators to be sure the module is op

erating

correctly

Use a programming device to verify that the NIM is logged into the P/C.

Connect the network cables to the NIM.

The following paragraphs provide detailed information for each step.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 117 118

Sin comentarios

Siemens SIMATIC TIWAY 1 Manual de usuario Pagina 41