Siemens EH.85M.21E Manual de usuario descargar pdf (Pagina 19)

ST800 FAULT REPORT CHECK LIST

Page 1 667/HB/27000/100 Issue 1

Visit Information

Site name: Date / Time: / / :

Engineer’s name: Telephone:

Reason for visit:

Controller Checks Before Resetting Faults

Are the signals still on? On q Off q System error LED? On q Off q

Green heartbeat LED? On q Off q Bus error LED? On q Off q

If on, is it still beating? Yes q No q Watchdog error LED? On q Off q

Enter the following commands and record the responses:

TOD PIC

CIC SIC

Type ‘FFS’ and use the ‘+’ key to scroll through the currently active fault log flags

until ‘FFS END OF LOG’ is displayed.

FFS +

Type ‘FDS’ and use the ‘+’ key to scroll through the currently active fault log data

until ‘FDS END OF LOG’ is displayed:-

If FFS 50 was set, i.e. if ‘FFS 50:255 LAMP’ was displayed, then enter ‘KLD’ and

use the ‘+’ key to scroll through the lamp faults until ‘KLD END OF LOG’ is

displayed:-

s a:nnW p/ccccc

æå

Examine the lamps around the junction.

Replace any lamps which have been correctly

reported as failed by KLD, tick the associated

box and check that the fault is automatically

cleared after about 10 seconds.

If no lamp fault can be found on the junction

for the displayed phase and colour, put a

cross in the box and refer to the ‘lamp monitor’

section of the ‘Information Sheets’.

1 2 ... 14 15 16 17 18 19 20

Sin comentarios

Siemens EH.85M.21E Manual de usuario Pagina 19