Siemens EH.85M.21E Manual de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 20
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
ST800 Guidance Notes
Issue 1 667/HB/27000/100 Page 15
FLF ABBR FLD Description
27
SCF1
18 Special Conditioning - General Fault 1
28
SCF2
19 Special Conditioning - General Fault 2
29
FLSH
- Special Conditioning - Fail Flashing Requested
30
to
37
- Not Used
38
NDIM
- No Dim/Bright Changes
No dim/bright changes were detected in a 24 hour period
although dimming is configured, see KDP. If either FLF 38 or
FLF 39 is set, then the controller will be forced into the bright
state.
39
DIM+
- Too Many Dim/Bright Changes
The number of dim/bright changes detected in a 24 hour
period exceeds the configured limit, see KDL. If either FLF
38 or FLF 39 is set, then the controller will be forced into the
bright state.
40
to
46
- Not Used
47
UINT
78 Unexpected Interrupt Occurred
48
FREQ
76-77 CPU Crystal Frequency Wrong
49
RTCH
- RTC Chip Failure
50
BATT
- RAM Battery Faulty On Power-Up
51
SDEN
- SDE/SA Not Selected But Board Fitted
52
SDED
- SDE/SA Data Altered By Handset
53
LINK
80 Pelican Link Fail
54
LMUF
- Lamp Monitor Internal Data Corruption
55
LAMP
(KLD) Any Lamp failure: Note that the fault log data is not held in
FLD but can be viewed using the handset command KLD.
56
PUFA
- First Puffin Failure
57
PUFB
- Second Puffin Failure
58
ANCL
81 Integral OTU Fault
59
IMU
82 Integral OMU Fault
60 - Not Allocated
61 - Not Allocated
62 - Not Allocated
63 - Not Allocated
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios