Siemens ET8 Series Instrucciones de operaciones descargar pdf (Pagina 8)

Additional Information CLV61x Dual Port (PROFINET IO)

3.2 Configuration of the CLV61x Dual Port via USB with SOPAS ET

The CLV61x Dual Port can be configured via SOPAS ET V2.38 (or higher) with a USB cable. The Micro-B

USB female connector is located under the rubber cover of the CLV61x Dual Port.

USB Micro-B

Select the network wizard in SOPAS ET and connect USB. SOPAS ET shows the USB connection of the

CLV61x Dual Port and its serial number as the communications interface.

In the SOPAS ET Network Scan Assistant, search by USB must be activated. The required SDD file of

the CLV61x Dual Port must be installed on the PC under SOPAS ET. It can take a relatively long time

depending on the ID sensor if not installed and the SDD file has to be loaded from the device. It is

recommended to install the required SDD file in advance under "Device Catalog / Install" either online or

via the Internet.

If the USB connection is established, SOPAS ET 3.x launches automatically. When using SOPAS 2.38.3,

always start SOPAS ET manually and connect it to the CLV61x Dual Port.

With the CLV61x Dual Port, SOPAS ET shows the firmware status of the device under “Service / Operating”

data.

In the configuration, the PROFINET parameters are then shown on the "Network/Interfaces/IOs /Profinet"

device page.

The PROFINET station name (= PN Station Name) is displayed here and can be changed. The PN station

name can also be changed by the PLC.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Sin comentarios

Siemens ET8 Series Instrucciones de operaciones Pagina 8