Siemens EF 83P Series Manual de instrucciones descargar pdf (Pagina 22)

1-12

7) Disassemble and clean the chuck periodically. Apply

grease to the chuck every day.

8) The solenoid valves become very hot when the

machine is operating. Be very carefully not to touch

them after the power in turned OFF.

9) Supply or change hydraulic oil or lubricating oil as

specified in the Instruction Manual.

10) Use only fresh, uncontaminated lubricating oil as

specified in the Instruction manual. Clean the

reservoirs and filers in the lubrication line periodically

and check for damages to the lubrication equipment

and piping.

11) The fan and filers in the electrical cabinet must be

kept clean.

12) Do not open the doors of the electrical cabinet, the

NC unit, or the operation panel unless absolutely

necessary. Opening the doors allows dust, foreign

matter, and moisture to enter the enclosure and can

cause machine malfunctions.

13) Before changing the battery for memory back up,

make sure that the power in turned ON. If the battery

is changed with power OFF, all programs, parameters,

and other data stored in memory will be lost.

14) The halogen lamp will be very for after it has been lit

for a long period. Be careful not to touch it.

15) Carry out daily, monthly, and semi-annual inspection

as specified in the Instruction Manual.

1.2.6 To Ensure High Accuracy

When operating a CNC lathe, the accuracy of the finished

product cannot be maintained unless the following check

points are observed. Failure to observe these check points

can also cause to accidents.

Check Points:

(1) Allow a sufficient clamping area so that the workpiece

will not come out of the chuck due to the cutting fore of

centrifugal force generated by spindle rotation.

Depending on the shape of the workpiece, it may need to

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 112 113

Sin comentarios

Siemens EF 83P Series Manual de instrucciones Pagina 22