Siemens EF 83P Series Manual de instrucciones descargar pdf (Pagina 18)

1-8

setup must be performed with the power ON, set the

switches on the operation panel to the following

positions:

1) Mode Selector Switch......................Handle

2) Spindle speed range.........................Natural

3) Chuck...............................................Unclamp

4) Spindle speed adjusting dial.............Lowest position

5) Turret index switch.........To the current turret position

6) Override switches.............................Lowest position

7) Machine lock....................................On

(4) When loosening the bolts on tool holders and cutting

tools, or loosening the tailstock body clap bolts, be sure

to loosen them gradually.

(5) When a manual chuck or manual fixture is used, always

remove the clamp handle from the chuck or fixture after

tightening.

(6) Specify a spindle speed which is permissible for the

chuck, cylinder, and fixture. If this condition is not

satisfied, the workpiece may come off the spindle,

injuring operators and damaging the machine.

(7) Select the proper chucking pressure and tailstock spindle

thrust pressure for the desired type of machining.

(8) Clamp the workpiece and cutting tools securely. Depth of

cut and cutting feed must be selected beginning with

small values.

(9) Carefully check the workpiece chucked conditions and

the center pressing conditions for center work operations.

(10) Make sure that the tool holders, tools, soft jaws, and

tailstock are all tightened securely. They should be

mounted and well balanced so that they will not interfere

with the workpiece or the machine.

(11) Be careful not to operate the wrong switch. Visually

check the switches on the operation panel before

operating them.

(12) The halogen lamp will be very hot after it gas been lit for

a long period. Be careful not to touch it.

(13) Always lower the spindle speed when changing the

spindle speed range while the spindle is rotating.

(14) While operate machine, do not touch or close to

movement zone, turning or movable unit will cause

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 112 113

Sin comentarios

Siemens EF 83P Series Manual de instrucciones Pagina 18