Siemens EF 7850 Series Especificaciones descargar pdf (Pagina 17)

04/04 Control via the Operator Panel

SINAMICS G130 - Operator Panel AOP30

Operating Manual

5-15

5.4 Parameterization Menu

You can adjust the chassis unit settings in the parameterization menu.

The drive software is modular. The individual modules are called DO

("DriveObject").

The following DOs are available in the G130:

• CU General parameters for the electronics module (CU320)

• Vector Drive control

• TM31 (optional) Terminal module TM31

Parameters with identical functions may exist with the same parameter number in

more than one DO (e.g. p0002 ).

The AOP30 is used for operating devices that comprise more than one drive (in

this respect, a regulated infeed is also a "drive") so that attention is focused on one

drive (i.e. the "current" drive). You can switch between the drives either in the

operation screen or in the main menu. The corresponding function key is labeled

"Drive".

This drive determines the following:

• Operation screen

• Fault and alarm displays

• Parameterization

Depending on your requirements, you can choose between two AOP display types:

1. All parameters

All the parameters for the current drive (see above), the CU, and all the other

device DOs are displayed in a list (as with older drives). The DO to which the

parameter currently selected belongs (inverted) is displayed in curly brackets in

the top left of the screen.

You can also select parameters for just one function group from this complete

list.

2. DO view

In this display, you can pre-select a DO so that only the parameters for this DO

are listed. This display is indicated by the text "DO" next to the DO designator in

curly brackets.

(The expert list in STARTER is only displayed in the DO view.)

In both cases, the set access level and the selected parameter group govern which

parameters are displayed. You can set the access level in the menu for inhibit

functions, which can be called up using the key button.

The parameters for access levels 1 and 2 are sufficient for simple applications. The

default setting is 1 Standard.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Sin comentarios

Siemens EF 7850 Series Especificaciones Pagina 17