SINAMICS G120
Inverter chassis units 0.37 kW to 132 kW (0.5 hp to 200 hp)
PM240 Power Modules
3/27
Siemens D 11.1 · 2008
3
■
Integration (continued)
Many system components for PM240 Power Modules are de-
signed as base components, that is, the component is mounted
on the baseplate and the PM240 Power Module above it in a
space-saving construction. Up to two base components can be
mounted above one another.
The following diagram shows the basic layout of a PM240 Power
Module with line reactor as base component. The line-side reac-
tors are equipped with terminals and the reactors at the Power
Module end with a pre-assembled cable. In the final installation
position, the mains terminals are at the top on frame sizes FSA
to FSC, and at the bottom on frame sizes FSD to FSE.
Basic layout of a PM240 Power Module with line reactor as base compo-
nent
If a class A line filter is installed in addition to the line reactor on
frame size FSA, the components must be arranged as shown in
the diagram below. In this case, the line supply connection is be-
low.
Power Modules of frame size FSB and higher are available with
integrated class A line filters; an external class A line filter is not
required in this case.
PM240 Power Module frame size FSA with line reactor and class A line
filter
PM240 Power Module frame size FSA with line reactor and output reactor
For configurations involving more than two base-type system
components, e.g. line filter + line reactor + output reactor, indi-
vidual components must be mounted to the side of the Power
Modules. In this instance, the line reactor and line filter must be
installed under the Power Module and the output reactor to the
side.
PM240 Power Module frame size FSA with line reactor, line filter and out-
put reactor
Power supply
G_D211_EN_00078a
Line
reactor
Power
module
Power supply
G_D211_EN_00079a
Line
reactor
Power
module
Line
filter
Power
supply
G_D211_EN_00185
Output
reactor
Power
module
Line
reactor
to the motor
Power
supply
G_D211_EN_00186
Output
reactor
Power
module
Line
filter
to the motor
Line
reactor
Comentarios a estos manuales