Siemens NRN 67 Series Especificaciones descargar pdf (Pagina 45)

RSSB Page 45 of 87

GSM-R user procedures (cab radio Version 2)

GSM-R GB

1A26

STOP EMERGENCY

Connected PTT

STOP EMERGENCY

GSM-R GB

1A26

Connected

General Broadcast

Wait until the railway emergency group call has ended and contact the signaller using a

point to point call. Do Not move your train until you have received enough information to

determine that your train is not affected by the emergency.

7.1.3.4 Instructed to remain at a stand by the signaller

In the event that a signaller has instructed you to remain at a stand; once the Railway

Emergency Group Call is terminated you should remain at a stand until contacted directly

by the signaller and authorised to move.

Note: Drivers must not contact the signaller with a request to restart and must take into

consideration that the signaller requires time to protect an area and manage the

emergency.

7.1.3.5 Receiving another railway emergency group call

If another GSM-R user makes a railway emergency group call in that affects your area,

this will be identified as another incoming call.

The new call will be shown on the bottom line of the cab radio display and the last line will

alternate between “Incoming” and “STOP EMERGENCY”.

GSM-R GB

1A26

STOP EMERGENCY

Connected PTT

Incoming

You should continue to take part in the ongoing call unless the signaller tells you to do

otherwise.

7.1.4 Receiving a general broadcast call

Signallers and operations controllers will use a

broadcast call to give out general information that

might affect the running of trains, for example,

warnings of service disruption on a particular

section of line.

The cab radio will show the same messages as

described in section 7.1.1. However, once the call is connected, the display will show the

type of call, that is, a General Broadcast call.

The signaller/operations controller will announce the General Broadcast with the following

standard introduction.

“This is a general broadcast from the signaller/operations controller at …………… to

all trains in the ………………. area.”

General Broadcast calls will end with the following voice message:

“…end of general broadcast.”

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 86 87

Comentarios a estos manuales

Sin comentarios

Siemens NRN 67 Series Especificaciones Pagina 45

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Siemens NRN 67 Series