Siemens SIMATIC TI505 Manual de usuario Pagina 81

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 91
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 80
Using the MODASST Program
D-2
SIMATIC TI505/TI500 MODNIM User Manual
D.1 Getting Started
MODASST
is a Configuration and Diagnostic Assistant software program
which can be used to help set up and use your MODNIM or TIW
A
Y Gateway
product. This program is provided to assist you in configuring the modules
and verifying that the module is communicating. The program can also help
verify that your MODNIM or TIW
A
Y Gateway is operational when you are
installing it.
The MODASST program provides diagrams of cable pin-outs, dipswitch
settings, and a facility to communicate with the MODNIM or TIW
AY
Gateway.
Y
ou will need the following components to run this program.
IBM
PC-compatible computer
The MODASST program
Serial communications port on your computer. (A mouse is optional.)
RS-232-C null-modem cable (the same cable as the one used from
MODNIM to Host, connected directly without modems).
T
o set up the hardware to use this program, find out the COM port number
you will use to communicate with the module, then follow these steps.
1.
Connect the cable from your computer communications port to either
one of the 25-pin connectors on the module.
2.
When safe to do so, power up the MODNIM and its associated PLC or
power up the TIW
A
Y Gateway module.
3. T
urn on the power on your computer
.
This program does not require any special installation to use. Y
ou may run
this program directly from the floppy disk or from a hard drive.
T
o run this program from the floppy disk, follow these steps.
1.
Insert the disk into the appropriate slot in your computer
.
2.
At the DOS prompt on your machine, type:
a:
Enter
modasst
Enter
Y
ou will now see the start-up screen. Press
Enter
to continue. The program
starts your configuration setup with the screen as shown in Figure D-1.
Overview
Hardware
Requirements
Running the
Pr
ogram fr
om the
Floppy Disk
Vista de pagina 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 90 91

Comentarios a estos manuales

Sin comentarios