Siemens SIMATIC TI505 Manual de usuario Pagina 21

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 91
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 20
Installation and Set-up
1-10
SIMATIC TI505/TI500 MODNIM User Manual
1.4 Installing the MODNIM
To
install the Series 505 MODNIM in the selected slot of the I/O base, follow
these steps.
To
avoid the possibility of personal injury, damage to the module,
altering the PLC memory
, or causing a PLC fatal error
, disconnect
power to the base’
s power supply and to any modules installed in
the base before inserting or removing the MODNIM.
1. Disconnect
power to the I/O base.
2.
Set the dipswitches, as described in Section 1.3. (See also Figure 1-8 for
example dipswitch configuration settings.)
3.
Position the module so that the front bezel is facing you.
4.
Hold the top and bottom of the bezel and carefully slide the module into
the slot, pushing it all the way into the base connector
. (See Figure 1-7.)
5.
Ensure that the edge card connector is firmly seated in the I/O base
connector.
6. T
ighten the screws at the top and bottom of the faceplate with a flat-
bladed screwdriver
. (These screws also ground the module to the base.)
Minimum
torque: 2.61 in-lb (0.3 N-m)
Maximum torque: 5.22 in-lb (0.6 N-m)
Figure 1-7 Installing
the Series 505 MODNIM in the I/O Base
Installing the
Series 505 MODNIM
in the I/O Base
WARNING
!
Vista de pagina 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 90 91

Comentarios a estos manuales

Sin comentarios