Siemens SIMATIC TI505 Manual de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 91
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
Installation and Set-up
1-4
SIMATIC TI505/TI500 MODNIM User Manual
1.2 Quick Reference Installation Steps
In
order to install and use the MODNIM module correctly
, you must meet
the following requirements.
Ensure that you have the appropriate MODNIM model.
The communications configurations of all devices attached to the
network must match; i.e., they must all have the same baud rate, stop
bits, parity
, handshaking, and transmission mode (ASCII or RTU).
Figure 1-2 provides a quick reference list of the basic steps for installing the
MODNIM.
Insert
module into selected I/O slot (Series 505) or two adjacent slots (Series 500).
Set configuration dipswitches.
Power up the I/O base.
Check MODNIM indicator lights.
V
erify MODNIM is logged into PLC.
Connect network cables.
Disconnect power to the I/O base.
Install power and I/O cabling.
Figure 1-2 Quick
Refer
ence Installation Pr
ocedures
General
Requirements
Procedures
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 90 91

Comentarios a estos manuales

Sin comentarios