Siemens TC35 Terminal Especificaciones descargar pdf (Pagina 25)

TC35i AT Command Set

Confidential / Released

TC35i_ATC_V01.05 Page 25 of 278 04.08.2003

2.7 ATD><n> Originate call to phone number selected from active memory

This command can be used to dial a phone number selected from the active memory. The active

memory is the phone book selected with AT+CPBS (see Chapter 4.33). To set up a call simply enter

the memory location of the desired entry. The memory location range of each phone book can be

queried by AT+CPBR (see Chapter 4.32).

Execute command

ATD><n>[<mgsm>];

TA attempts to set up an outgoing call to the stored number.

The command may be aborted generally by receiving a character during

execution. Abortion is not possible during some states of connection setup

such as handshaking.

Response

If error is related to ME functionality:

+CME ERROR: <err>

If no dialtone (parameter setting ATX2 or ATX4):

NO DIALTONE

If busy (parameter setting ATX3 or ATX4):

BUSY

If a connection cannot be set up:

NO CARRIER

If successfully connected:

Parameter

<n> Integer type memory location should be in the range of locations

available in the memory used, i.e. the <location> number returned

by AT+CPBR.

<mgsm> String of GSM modifiers:

I Activates CLIR (disables presentation of own phone number to

called party)

i Deactivates CLIR (enables presentation of own phone number

to called party)

<;> The semicolon is mandatory since dialing from a phone book is

only supported for voice calls.

Reference

V.25ter/GSM 07.07

Note

· Parameter <mgsm> only if no *# code is within the dial string.

· The command is not applicable to data calls. Any attempt to dial a data

call number from <mem> causes the result code “NO CARRIER” to ap-

pear.

· *# codes sent with ATD are treated as voice calls. Therefore, the com-

mand must be terminated with a semicolon “;”.

· See ATX command in Chapter 2.31 for setting result code and call moni-

toring parameters.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 277 278

Comentarios a estos manuales

Sin comentarios

Siemens TC35 Terminal Especificaciones Pagina 25

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Siemens TC35 Terminal