Siemens DTU3005-B Manual del operador descargar pdf (Pagina 56)

8 Setting Options

52 Siemens Energy & Automation, Inc.

8 Setting Options

The Options menu allows you to configure settings for

the DTU3005 Editor software and to load and save

these settings. Options include the directory to which

the program stores its project files, which COM port

and printer port the program uses, and printer set-

tings.

Until you save the Options to the PC hard drive (i.e.,

disk), any changes you make using the Options menu

are only effective while you are running the Editor

software. If you exit the Editor software without saving

the Options to disk, any changes that you made will be

considered temporary and will not be saved.

Select Options from the main menu to display the

Options menu as shown below. The following menu

items are available:

• Set Directory—changes the directory location on

your hard drive where project files are saved and

stored.

• Set COM Port—indicates which COM port on your

computer is used to upload and download

projects to the DTU3005 unit.

• Setup Printer—allows you to indicate which

printer you want to use to print out the project file

information. It also allows you to print to a file on

the hard drive, and indicate how many lines your

printer prints per page.

• Load Options from Disk—loads previously saved

Options from the Editor.cfg file on the hard

drive.

• Save Options to Disk—saves your Options to the

Editor.cfg file on the hard drive, which makes

these settings the new options.

• Default Options—resets the Option settings to the

original default settings, which are the options

that were in effect when the program was first

installed and operated.

8.1 Setting the Project Directory

The DTU3005 Editor software saves all the project files

to a designated project directory. The default directory

is named “PROJECTS” and is located inside the Edi-

tor’s program directory. If you want to use a different

directory or drive, you can set the new directory using

the Set Directory command. Some reasons you may

want to change the directory are:

• To save the project files to a floppy disk or a net-

work drive for security and archiving.

• To save the project files in the same location as

other files, such as CAD drawings and specs, per-

taining to your equipment.

• To save project files from different installations in

separate directories.

1. To change the default project directory, select Set

Directory from the Options menu. The Set

Projects Directory screen appears:

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 140 141

Comentarios a estos manuales

Sin comentarios

Siemens DTU3005-B Manual del operador Pagina 56

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Siemens DTU3005-B