Siemens SIMATIC NET Especificaciones descargar pdf (Pagina 97)

Chapter 7. Sample Configurations 87

[4] Click the Properties button. When the Properties dialog box appears, click the

Profibus tab.

[5] Clear the PG/PC is the only master on the bus check box.

[6] Record the value listed in the Timeout field. You will need this value for

configuring the Power Tool.

[7] Click the SAPI S7 tab and select the Search button. The Search Database

dialog box appears.

[8] Locate the binary connection database you created earlier and click OK to

save your database selection.

[9] Repeat steps 3 to 8 until all your communication processors are defined.

Once SIMATIC NET is configured, you are ready to configure the SI7 driver with the

Power Tool.

[1] Start the Power Tool and select Setup from the Options menu. When the

Power Tool dialog box appears, select the Advanced tab.

[2] Enter the timeout value you recorded earlier in the Global Timeout field. If

you need to change this value in the Power Tool, make sure you adjust the

timeout value in the PG/PC Interface program to match.

[3] Add a channel and select one of the communication processors you listed from

the Communication Processor field.

[4] Select a virtual field device for the selected communication processor from the

Virtual Field Device field.

[5] Enable the channel and add a device.

[6] Select a connection for the device from the Connection field.

[7] Enable the device and add the datablocks you need. Remember to enable each

datablock so that it can communicate with the process hardware.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 267 268

Sin comentarios

Siemens SIMATIC NET Especificaciones Pagina 97