Siemens SIMATIC NET Especificaciones descargar pdf (Pagina 111)

Chapter 7. Sample Configurations 101

[4] Click the Properties button. The Properties dialog box appears.

[5] Click the S7 Protocol tab and select the Search button. The Search Database

dialog box appears.

[6] Locate the binary connection database you created earlier.

[7] Click OK to save your database selection.

[8] Repeat steps 3 to 7 until all your communication processors are defined.

Once SIMATIC NET is configured, you are ready to configure the SI7 driver with the

Power Tool.

[1] Start the Power Tool and add a channel.

[2] Select one of the communication processors you added from the

Communication Processor field.

[3] Select a virtual field device for the selected communication processor from the

Virtual Field Device field.

[4] Enable the channel and add a device.

[5] Select a connection for the device from the Connection field.

[6] Enable the device and add the datablocks you need. Remember to enable each

datablock so it can communicate with the process hardware.

Using the MPI Port

You can establish communication between the SCADA server and an S7 300 or S7

400 using the Multi-Port interface (MPI) connection on the PLC. This configuration

requires you to install a CP 5611 interface card in your SCADA server. Once you

install the interface card, cable the SCADA server to your PLC using one of the

following photographs:

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 267 268

Sin comentarios

Siemens SIMATIC NET Especificaciones Pagina 111