Siemens SIMATIC NET Especificaciones descargar pdf (Pagina 217)

Chapter 12. Checking Communication 207

12. Checking Communication

You can verify that communication between FIX/iFIX software and the process

hardware is correct by using the following step-by-step procedure for setting up a

single data link and configuring the SI7 driver. The procedure consists of the

following three tasks:

[1] Adding the SI7 driver to your SCADA configuration and launching the SI7

Power Tool.

[2] Configuring a device with the Power Tool.

[3] Adding a data link to an operator display in the Intellution WorkSpace to

ensure you can send and receive data between the process hardware and the

SI7 driver.

To add the SI7 I/O driver to a SCADA configuration and launch the SI7 I/O Driver

Power Tool

[1] Start the System Configuration Utility (SCU):

[a] Select Programs from the Start menu.

[b] Select Intellution FIX or iFIX from the Programs menu.

[c] Select System Configuration from the pop-up menu that appears.

[2] Select SCADA from the Configure menu. The SCADA Configuration dialog

box appears.

[3] Click the question mark (?) next to the I/O Driver Name field. A list of drivers

installed on the local node appears.

[4] Select the SI7 I/O driver and click Add. The SI7 I/O driver adds to the

Configured I/O Drivers list.

[5] Click OK to close the SCADA Configuration dialog box and select Tasks

from the Configure menu. The Task Configuration dialog box appears.

[6] Verify that I/O Control appears in the Configured Task list box.

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 267 268

Sin comentarios

Siemens SIMATIC NET Especificaciones Pagina 217