Siemens FIREFINDER-XLS Manual de inicio rápido descargar pdf (Pagina 26)

3-4 OPERATION

FIREFINDER-XLS INSTALLATION, OPERATION AND MAINTENANCE MANUAL | CHAPTER 3

In addition, the System responds to alarms with other output functions (as pro-

grammed in the Zeus tool) such as other audible signals.

An Acknowledge Alarms soft key displays in the bottom left corner of the screen.

Press this key to acknowledge each alarm and to silence the local audible. The

blinking exclamation point (!) then changes to a check mark ()). See Figure 3-4. (If the

system is programmed as NFPA 72D in the Zeus tool, it is necessary to individually

acknowledge each alarm.)

Highlight an event and press the

More Info/+ button to go to the

Devices screen, as shown in Figure

3-5. If the selected item is part of a

group, the device list will show the

primitive (individual) devices cur-

rently off-normal in the event queue.

All events in a group of the same

type (i.e., Alarm, Trouble) display

together in the devices screen.

Primitive devices that are not part of

a group display by themselves.

Depending on how the system is

programmed in Zeus, the top event

can be a device or a group.

WHERE:

First Floor Reception Area is the Group Message

! is an active event; ) is an acknowledged event

HFP-11 @ address 3:15 is the device custom message

HFP11 is the event device

10:56 is the event time

3:15 is the event device address

Smoke is the component category

Photoelectric sensor is the event device component

Pressing the Details soft key takes

you to the Details screen as shown

in Figure 3-6. The Details screen

contains information that has been

entered using the Zeus program-

ming tool, such as additional

information about the alarm location,

the number of devices in alarm (this

number can be more than one

when the device is part of a

group), the alarm types, the name

and phone number of a contact

person, icons showing the fire

equipment in the area and icons

showing special conditions.

Press the Map soft key to display a map showing the location of the event, provided

the information has been programmed using the Zeus tool. Refer to Figure 3-7. Maps

can be programmed to provide icons showing the event type. These icons are the

Figure 3-5

Alarm Devices Screen

Contact: John Sample

Phone #: 973.555.1234

AREA FIRE EQUIP:

AREA CONTAINS:

DETAILS

MAP DEVICES

BACK

ALARM LOCATION:

1st Floor Reception Area

- Lobby entrance

# Devices in ALARM: 3

ALARM TYPES:

Smoke, Heat, Flow

First Floor Reception Area

Figure 3-6

Alarm Details Screen

DETAILS

MAP DEVICES

BACK

HFP-11@address 3:15

:3-15HFP11 10:56

First Floor Reception Area

Smoke

Photoelectric sensor

HFP-11@address 3:16

:3-16HFP11 10:57 Smoke

Photoelectric sensor

HFP-11@address 3:17

:3-17HFP11 10:58 Smoke

Photoelectric sensor

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 71 72

Comentarios a estos manuales

Sin comentarios

Siemens FIREFINDER-XLS Manual de inicio rápido Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens FIREFINDER-XLS