Siemens SPCK620 Guía de usuario Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 43
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
7
User programming via the keypad
User Menus
36
Siemens AB
A6V10271018
Security Products
26.09.2011
****.XA1.OFF
**** LOG
****.LOG
Up to 10 recent events displayed
Recent events
**** ENGA.ON
****.ENGA.ON
ENG.ON
Enable Engineer access
Engineer status
**** ENGA.OFF
****.ENGA.OFF
ENG.OFF
Disable Engineer access
Engineer status
**** MANA.ON
****.MANA.ON
Enable Manufacturer access
Manufacturer status
**** MANA.OFF
****.MANA.OFF
Disable Manufacturer access
Manufacturer status
**** O5.ON
****.O5.ON
Where mapping gate is identified as “O5”, it
is triggered on
Status of “O5”
**** O5.OFF
****.O5.OFF
Where mapping gate is identified as “O5”, it
is triggered off
Status of “O5”
****.ASET
Allows Partset A of alarm by SMS
****.BSET
Allows Partset B of alarm by SMS
****.CLR
Allows clear alerts by SMS
For SMS recognition, mapping gate identification uses the format ONNN, where
O stands for mapping gate, and NNN are the numeric placeholders, of which not
all are necessary.
(Example: O5 for mapping gate 5)
For SMS recognition, X-10 device uses the format: XYNN, where X stands for X-
10; Y stands for the alphabetic identity and NN are the available numeric
placeholders. (Example: XA1)
The SMS operates using a standard protocol that is used in SMS telephones.
Please note that some PSTN operators do not provide the service of SMS over
PSTN. For SMS to operate over PSTN the following criteria is required:
Caller ID needs to be enabled on the telephone line.
Direct telephone line not through PABX or other comms equipment.
Please also note that most Service Providers only allow SMS to a telephone
registered in the same country. (This is due to billing issues)
7.1.11 DOOR CONTROL
This option allows you to control all the doors of the system.
1. Scroll to DOOR CONTROL and press SELECT.
2. Select the door which should be controlled and press SELECT.
3. Select one of the door states listed below as new door state and press
SELECT.
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43

Comentarios a estos manuales

Sin comentarios