
User programming via the keypad
The keypad displays UPDATED once the setting has been saved
Reported events
To select events for SMS notification:
1. Scroll to SMS EVENTS and press SELECT.
2. Select EDIT NUMBER and press SELECT.
3. Scroll to the appropriate enabled number and press SELECT.
4. Scroll to REPORTED EVENTS and press SELECT.
5. Scroll to the desired event notification.
Events selected are displayed preceded by an asterisk.
6. Press BACK to exit.
7.1.10.3 SMS Commands
Once the SMS setup and configuration is complete, SMS features may be
activated. Commands, depending on SMS configuration are sent using a code or
caller ID. The type of code depends on what is set for SMS Authentication. See
page.
The table below provides all available SMS commands. Subsequent action and
response are also provided.
SMS Commands are sent as texts to the phone number of the SIM card on the
controller.
For commands using code, the format of the text is the code followed by either a
space or a full stop. Where **** is the code and “command” is the command:
****.command or **** command.
For example, the command “HELP” is this text: **** HELP or ****.HELP
All available commands displayed
Time/date of system
set. If applicable,
responds with open
zones/forceset
zones
Status of system and
applicable areas
Where X10 device is identified as “A1”, it is
triggered on.
Where X10 device is identified as “A1”, it is
triggered off.
Comentarios a estos manuales