Siemens TL.. Instrucciones de operaciones descargar pdf (Pagina 40)

Application

3.15 Moving the cabinets

Use a crowbar to lift the cabinet so that you can place the rollers under the frame. If you want to change

the rolling direction, you must lift the cabinet again, turn the rollers by 90° and place them under the

frame again.

You may need to strengthen the floor (with metal sheets) before you move the cabinets over it. Make

sure that the metal sheets are placed such that you will be able to remove them again once the inverters

have been installed.

In order to move or roll the cabinet off the pallet, you will need a solid metal bar or a strong pipe of

100 cm in length and 6 cm in diameter. Then proceed as follows:

• Adjust the pallet so that it is level with the adjacent surface (e.g. floor of the equipment room).

• Cover the gap between the pallet and floor with a metal sheet (5 to 10 cm) so that the rollers do

not get caught in the gap.

• Place a roller on the metal sheet and under the cabinet frame.

• Place a thick roller under the cabinet at a position where there are no cross-planks in the pallet.

• With the assistance of installation personnel, push the cabinet off the pallet.

• As the cabinet moves forward, place more rollers underneath.

NOTE

Use thick-walled steel rods. Round steel bars, round wooden timbers, or steel rollers enclosed in concrete are also suitable for

the purpose.

The bars must have a minimum diameter of 6 cm.

The bars must be at least 1/5 longer than the transportation unit / cabinet.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 60 61

Sin comentarios

Siemens TL.. Instrucciones de operaciones Pagina 40