Siemens ET 78X Series Instrucciones de operaciones Pagina 226

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 349
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 225
DNC Plant/DNC Cell (FBDN1) 05.07
10 Configuration
© Siemens AG 2010 All Rights Reserved
FBDN1/10-218 Motion Control Information System DNC (FBDN) - 04/10 Edition
10.5.6 Configuration dialog for the tool setting device
General
Tool setting devices are always inserted directly underneath the plant root.
Fig. 10-25: Properties of tool setting device
Station
The assignment of a tool setting device to the HMI workstation is made via the
station name, which must be unique in DNC Plant. This entry is not necessary in
DNC Cell because there is only one station.
Note
The station name configured for a tool setting device must not be
used for any other tool setting device or machine. When you confirm
the Properties dialog, a plausibility check is carried out to determine
whether the station name has already been assigned to a tool
setting device or a machine. In this case, the dialog remains open
until a correct station name has been entered.
Transmission module
Vista de pagina 225
1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 348 349

Comentarios a estos manuales

Sin comentarios