Siemens ITC Instrucciones de operaciones descargar pdf (Pagina 50)

Assigning device parameters

5.3 Configuration settings of the device

Industrial Thin Client ITC1200, ITC1500, ITC1900, ITC2200

50 Operating Instructions, 04/2013, A5E03474888-02

5.3.5 Connections

5.3.5.1 Basics

Introduction

Users can connect from the Thin Client to different servers. Example:

● RDP Server 1: Access to office planning documents

● VNC Server 2: Access to Office spreadsheets

● Sm@rtServer 3: Access to WinCC messages at the plant

● SINUMERIK Server 4: Access to a SINUMERIK plant screen

● Web Server 5: Access to web-based content, for example, of an S7 controller

(PROFINET) or Intranet/Internet using the integrated web browser.

Note

Web connection and web browser

You can configure a web connection, for example, the server address, in the Connection

setting

s (Page 54). You configure the web browser its

elf, for example, its proxy settings,

in the Application settings (Page 64).

You can establish up to 5 such client-server connections at the same time. These

connections are specified mainly by the following parameters:

● Connection type, e.g., "Sm@rtServer" or "RDP"

● IP address of the server

● Port of the server

The Industrial Thin Client then displays the server screen as a full screen.

This section shows how you configure client-server connections. The connection settings

can be found in the configuration settings in the Start menu "Configuration > Connections".

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 131 132

Sin comentarios

Siemens ITC Instrucciones de operaciones Pagina 50