Siemens ITC Instrucciones de operaciones descargar pdf (Pagina 46)

Assigning device parameters

5.3 Configuration settings of the device

Industrial Thin Client ITC1200, ITC1500, ITC1900, ITC2200

46 Operating Instructions, 04/2013, A5E03474888-02

5.3.4 Network settings

Introduction

The following figure shows the network settings in the Start menu "Configuration > Network".

You can perform the following actions:

● Specify network parameters

● Assign network parameters dynamically

● Use DNS server

● Check valid settings

● Specify speed and mode of the connection

Note

These network settings are not relevant for the SINUMERIK connection. The SINUMERIK

connection automatically obtains its network settings from the system network.

Note

During a SINUMERIK connection, a new IP address is assigned to the device with the

following effect:

 Any active RDP connection is terminated.

 Remote maintenance of the device is no longer possible.

When the SINUMERIK connection is closed, the original IP address is restored.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 131 132

Sin comentarios

Siemens ITC Instrucciones de operaciones Pagina 46