
4 Communication settings and guide of HMI connecting with controller
———
———
Note:Order code refer to the ADAM-4107 manual
1、 “Data type” of S_Channel and A_Channel is signed integer. Decimal digits is 2 when the power
supply is 500mv or 150mv, other conditions is 3.
2、 “Data type” of other registers is HEXING
3、M_channel($AA5VV):At the same time allow multiplexing.
Enter the decimal value in the range of 0 to 255, mapping hexadecimal (00-FF)
255(FF):0-7 channel show.
127(7F):0-6 channel show, 7 Channel does not show.
ADAM-4015
Device Bit Address Word Address Format Notes
Channel ------ Channel 0-5 D Floating
Note: Channel 0-5 data type is floating.
◎Cable Diagram
HMI
terminal
9pin D-SUB female/male
Controller
RS485 terminal
DATA-
DATA+
1 RX
-
6 RX+
com0/com1
4.5 AysjNet
◎Serial Communication
Series CPU Link Module Driver
Compressor Controller KYK3-K RS485 on port AysjNet
◎System configuration
Compressor
Controller
KYK3-K RS485 on port RS485
Setting Your owner cable
- 28 -
Comentarios a estos manuales