Siemens EK 746 Series Instrucciones de operaciones descargar pdf (Pagina 50)

Connecting up

6.5 Connecting a power supply adapter

SCALANCE W786 outdoor access point

50 Operating Instructions, 06/2013, A5E02280428-08

The following applies to the

PS791-2AC (AC 100 – 240 V)

only:

WARNING

Danger from line voltage

The strain relief clamp may damage the insulation under unfavorable circumstances. You

run the risk of encountering danger from line voltage through the strain relief clamp.

For a line with 100 to 240 VAC use an insulated strain relief clamp only; it is included in the

scope of delivery for the power supply adapter!

How to remove the power supply adapter

Follow the steps below to remove a power supply adapter from a SCALANCE W786:

WARNING

Danger from line voltage

Only electrical specialists may open the device and remove the power supply adapter!

Connect or disconnect power supply cables only when the power is turned off!

1. Disconnect the power supply cable from the power supply adapter.

2. Loosen the securing screw of the power supply adapter (position

in the figure above).

3. Pull the loop (position

in the figure above) to remove the connector on the rear of the

power supply adapter from the socket in the housing and remove the power supply

adapter.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 89 90

Sin comentarios

Siemens EK 746 Series Instrucciones de operaciones Pagina 50