
Section 2 Installation Mounting and Removing S800 I/O Units
3BSE056248 25
Figure 12. Mounting of I/O module on MTU
At the mounting of a S800 I/O Box on a Termination Unit the following should
be observed:
Press the Box straight and right on to stop into the Termination Unit. Above
shown angle shall be 0°.
Turn the Locking Device clockwise to its end position. Above shown state with
the Locking Device in a position before end position shall not exist for an active
module.
Do not turn the I/O Module Lock/Switch counter-clockwise from the unlocked
position. This will cause it to break and will make the MTU and the I/O module
inoperative.
Comentarios a estos manuales