Siemens CM343 Series Manual de servicio descargar pdf (Pagina 57)

5 Using the Command Interface

CP 343−2 / CP 343−2 P AS−Interface Master

Release 08/2008

C79000−G8976−C149−04

Table 6-2 Error Coding, continued

DONE MeaningSTATUSERROR

0 1 80C6H Data record transfer aborted due to priority class abort

(warm restart or background) of the distributed I/Os.

0 0 8181H Job active (no error)

0 1 8182H ID from block execution with STARTUP=TRUE (not an

error)

0 1 8184H Data type of the RECV formal parameter illegal

0 1 8185H Communications errors with the AS−i master

0 1 8381

The AS-i slave address is incorrect

0 1 8382

The AS-i slave is not activated (not in LAS).

0 1 8383

Error on the AS-Interface

0 1 8384

Command not permitted in the current status of the AS-i

master.

0 1 8385

An AS-i slave with address 0 exists.

8386

The AS-i slave has illegal configuration data (I/O or ID

codes).

0 1 83A1H The addressed AS-i slave was not found on the

AS-Interface.

0 1 83A2H An AS-i slave with address 0 exists.

0 1 83A3H An AS-i slave with the new address already exists on the

AS-Interface.

0 1 83A4H The AS-i slave address cannot be deleted.

0 1 83A5H The AS-i slave address cannot be set.

0 1 83A6H The AS-i slave address cannot be stored permanently.

0 1 83A7H Error reading the extended ID1 code.

0 1 83A8H The target address is not plausible (for example a B slave

address was used for a standard slave).

0 1 83B1H A length error occurred transferring a string.

0 1 83B2H A protocol error occurred transferring a string.

0 1 83F8H The job number or the job parameter is unknown.

0 1 83F9H The AS-i master has detected an EEPROM error.

0 1 8F22H Area length area reading a parameter

8F23H Area length error writing a parameter

This error code indicates that a parameter is entirely or

partly outside the address area or that the length of a bit

array of an ANY parameter cannot be divided by 8.

0 1 8F24H Area error reading a parameter

8F25H Area error writing a parameter

This error codes indicates that a parameter is located in an

area that is illegal for a system function.

0 1 8F28H Alignment error reading a parameter

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 139 140

Comentarios a estos manuales

Sin comentarios

Siemens CM343 Series Manual de servicio Pagina 57

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Siemens CM343 Series