Siemens SIMATIC NET CP 343-1 Manual de usuario descargar pdf (Pagina 41)

CP 343-1

Manual, 10/2012, C79000−G8976−C201-07

Notes on configuration and operation

NOTICE

The front panel must be kept closed during operation.

6.1 Project engineering

Project engineering

To set up the CP for communication services, read the information on configuring in the

sections Project engineering (Page 26) and Replacing a module without a programming

devi

ce (Page 59). For detailed information on co

nfiguration, refer to Part A of this manual,

see References /1/ (Page 68).

6.2 Controlling the mode

You have the option of changing the mode of the CP between RUN and STOP using the

STEP 7 configuration software (PLC > Accessible Nodes).

Change from STOP to RUN

The CP loads configured and/or downloaded data into the work memory and then changes

to RUN mode.

Change from RUN to STOP

The CP changes to STOP - transitional phase with LED display "Stopping (RUN → STOP").

● Established connections of the open communications services (see also section

Communication services (Page 10)) are terminated.

● The followi

ng functions are disabled:

– PROFINET IO

– Time-of-day synchronization

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 75 76

Sin comentarios

Siemens SIMATIC NET CP 343-1 Manual de usuario Pagina 41