Siemens RUGGEDCOM RSG2200 Guía de usuario descargar pdf (Pagina 151)

RUGGEDCOM ROS

User Guide

Chapter 5

Setup and Configuration

Configuring the DNP Protocol 139

Figure 94: DNP Form

1. Transport Options 2. IP Port Box 3. Remote UDP Port Options 4. Learning Box 5. Aging Timer Box 6. Link Stats

Options 7. DSCP Box 8. Apply Button 9. Reload Button

3. Configure the following parameter(s) as required:

Parameter Description

Transport Synopsis: { TCP, UDP, Disabled }

Default: TCP

The network transport used to transport protocol data over an IP network.

IP Port Synopsis: 1024 to 65535

Default: 20000

A local port number on which the DNP protocol listens for UDP datagrams.

Remote UDP Port Synopsis: { IP Port, Learn }

Default: IP Port

The IP port on which remote device listens to UDP datagrams. This port is either the

same IP port that devices in all networks listen to, or can be learned from the UDP

datagram.

Learning Synopsis: ###.###.###.### where ### ranges from 0 to 255 or { Disabled }

Default: Disabled

Enable or disable address learning. Learning can be disabled or enabled on a

management IP interface (empty string), or enabled on the interface with a specific IP

address. If learning is enabled and the remote address is not known, a UDP broadcast

message will be sent and source addresses will be learned on devices that run the DNP

protocol. If the local address is not known, a message will be sent to all serial ports

running the DNP protocol. Local addresses will be learned from local responses. If the

TCP transport is configured, a connection will be established to the devices with the

corresponding IP address.

4. Click Apply.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 169 170

Sin comentarios

Siemens RUGGEDCOM RSG2200 Guía de usuario Pagina 151