Siemens TC35 Manual de usuario descargar pdf (Pagina 3)

01-09-09

Written by Darren Bagshaw v1.1 3

4.10. Click Modem -> configure target modem

4.11. Click Configure, If everything is correct, the message box will display the following

messages – Baudrate Autosearching -> sending modem settings -> Configuration procedure

finished successfully

o If error 1602 occurs, either the wrong com port has been selected or the modem is

not switched on. Recheck these settings and try again.

4.12. When the configuration has completed successfully, close the Modem configuration

window down using the cross in the top right of the window.

4.13. To check the Modem and SIM are working correctly, position the aerial in a good

signal area (see chapter 7) Select Modem -> Make modem connection. At this point, the

telephone/mobile phone selected in point 9. should start to ring. Hang up immediately and

the connection will terminate. The modem has now been configured and is now working

correctly.

o If the telephone does not start ringing and the error message “NO CARRIER”

appears, the SIM chip inserted into the Modem does not have GSM enabled.

Contact your Service provider to make sure this is the default service for your SIM

card.

o If error 1603 occurs, the SIM is not inserted correctly or is not being detected.

Remove the SIM, clean the metal pads with your thumb and try again

4.14. Disconnect the modem and connect the other modem to the computer. Repeat steps

10 to 13 to configure the modem and ensure it is working.

5. Connecting the Modem to the MI2292 instrument

5.1. Ensure both the MI2292 and the GSM modem

are turned off.

5.2. Connect one end of the Male to Male serial

(RS232) cable to the port on the right hand

side of the instrument

5.3. Connect the other end of the cable to the GSM

modem.

5.4. Connect the Aerial to the GSM modem

5.5. Connect the Power cable to the GSM modem

and turn on both the modem and the

instrument.

6. Setting up the MI2292 Power Quality Analyser PLUS

6.1.Switch on the instrument, ensure that the instrument is not recording and then turn the right

hand dial to CONFIG

6.2.From the menu, highlight in black using the up and down arrow keys the SYSTEM option

and press the Enter button (a password may be prompted for at this point, for default

passwords, please see the MI2292 user manual).

1 2 3 4 5

Sin comentarios

Siemens TC35 Manual de usuario Pagina 3