
72
Service (Customer Care)
Gigaset SL785 / GBR / A31008-M2009-L101-1-7619 / appendix.fm / 02.12.2008
Version 4, 16.09.2005
Gigaset SL785 only
Authorisation
This device is intended for analogue
phone lines in the UK.
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the essen-
tial requirements and other relevant regu-
lations laid down in Directive 1999/5/EC.
A copy of the 1999/5/EC Declaration of
Conformity is available at this Internet
address:
www.gigaset.com/docs
.
Bluetooth
ò
Qualified Design Identity
The Bluetooth QD ID for your
Gigaset SL78H is: B013322.
The other party cannot hear you.
You have pressed the §Mute§ display key.
The handset is "muted".
¥ Activate the microphone again
(
¢ page 29).
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥ The caller should ask the network provider
to release Calling Line Identification (CLI).
You hear an error tone when keying an
input (a descending tone sequence).
Action has failed/invalid input.
¥ Repeat the operation.
Watch the display and refer to the user
guide if necessary.
You cannot listen to messages on the net-
work mailbox.
Your PABX is set for dial pulsing.
¥ Set your PABX to touch tone dialling.
No time is specified for a message in the
calls list.
Date and time have not been set.
¥ Set the date/time (¢ page 15).
The answering machine announces "PIN is
incorrect" during remote operation.
1. You have entered the wrong system PIN.
¥ Enter the system PIN again.
2. The system PIN is still set to 0000.
¥ Change the system PIN (¢ page 68).
The answering machine is not recording any
messages/has switched over to answer only.
Its memory is full.
¥ Delete old messages.
¥ Play back new messages and delete.
Comentarios a estos manuales