Siemens IFP1900 Instrucciones de operaciones descargar pdf (Pagina 31)

Installing and connecting the device

3.2 Mounting the device

Industrial Flat Panel IFP1500, IFP1900, IFP2200

Operating Instructions, 11/2014, A5E31298376-AC

3.2.3

Fastening the device with mounting clips or mounting brackets

Requirement

● All packaging components and protective films have been removed from the device.

● The mounting clips included in the accessory kit are to hand.

Procedure

Note

If the mounting seal is damaged, the degree of protection is not guaranteed.

Proceed as follows:

Working from the front, insert

the device into the mounting

cut-out. Secure the device to

prevent it from falling out.

Insert a mounting c

lip into the

cutout provided on the

device. Make sure it is in the

correct position; see the

section "Mounting clips or

mounting brackets, position

for IP65 (Page 29)".

Tighten the threaded pin to

secure the mounting clip. The

maximum torque when

tightening the threaded pins

of the mounting clips is 0.5

Nm.

Repeat steps 2 and 3 for all

mounting clips.

Check the fit of the mounting

seal.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 93 94

Sin comentarios

Siemens IFP1900 Instrucciones de operaciones Pagina 31