Siemens TC65 Manual de usuario descargar pdf (Pagina 21)

TC65Smart

User Manual

Rev. 2-1.0 21

TC65_DTR_OFF

0x12 0x00-

0xFF

The command sets up the mode of hardware

disabling of the enabled module by the DTR

signal. The value of the operand determined

the delay in x100ms (0-25.4c) since the

time of removal of the active DTR signal.

(< 0V) until the time of automatic disabling

of the module. The value 0xFF disables the

automatic disabling mode. The value 0x00

initiates the automatic disabling at once

after the signal transmission. The value is

saved in the non-volatile memory. The

value on default is 0xFF (disabled). During

the timing the indicator “PWR/STATE”

flashes intermittently.

<aFE12xx>

SIM_change

0x40 0x00,

0x01

The command initiates the procedure for

SIM card switching over. The operand

determines the number of the required SIM

mount (0 – the “SIM1” mount, 1 – the

“SIM2” mount). The switching procedure

goes along with the CCIN signal

transmitted to the module, which makes it

possible to disable the SIM interface at the

switching moment, and the automatic start

of registration in the network after the

procedure is completed. If the SIM card

“tray” is unavailable in the mount required

by the command, the switching procedure is

disabled. If the required mount is already

active, the operator is repeatedly registered

in the network. The selected value of the

mount number is saved in the non-volatile

memory of the controller. The last selected

mount is automatically selected upon

power-on. Selection of the mount is

indicated by the corresp. indicators “SIM1”

and “SIM2”.

<aFE4000> /

<aFE4001>

I2C_adr

0x70 0x00 –

0x7F

The command makes it possible to specify

the Controller address on the bus-line I2C.

On this address TC65 will address to the

Controller. It should not be forgotten that

the address byte of the bus-line I2C

contains the address in the higher 7 bits.

The lower bit is used as a reading/recording

marker. If this command transmits the

address 0x7F, the recording commands

must be transmitted to the address 0xFE, the

reading commands – to 0xFF (the

instruction operand shifted to the left by 1

position). It is saved in the non-volatile

memory. The initial value is 0x7F (0xFE-

recording, 0xFF-reading). The controller

jumps to the new address at once after the

command is received.

<aFE7002> -

switching over

from the

address 0x7F

(0xFE/0xFF)

to the address

0x02

(0x01/0x00)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Comentarios a estos manuales

Sin comentarios