Siemens FIREFINDER-XLS Manual de usuario descargar pdf (Pagina 3)

s Industry, Inc.

Building Technologies Division

LVM

— Live Voice Module

Model LVM provides a supervised, high-quality and

dynamic microphone as a means of sending live voice

messages to specified audio zones. Model LVM

mounts on the inner door of a Model CAB1, Model

CAB2, Model CAB3 or remote lobby enclosure. Model

LVM includes a microphone with a push-to-talk switch and

retractable coiled cord. The microphone and push-to-talk

switch are fully supervised.

Model LVM also provides a green pre-announce LED that

indicates the pre-announce signal is active at the selected

zones and a green ready to page LED, which indicates

selected zones are ready to be paged. The pre-announce

signal can be programmed as a tone or message and the

duration is adjustable from 0 to 10 seconds in one-second

increments. A built-in speaker with volume control allows

the monitoring of the audio channels.

The front panel of Model LVM contains six (6) switches and

six (6) pairs of LEDs. Each pair contains one (1) dual-color

(red / green) and one yellow LED. These switches can be

programmed for manual voice functions as well as

generic system functions. When the switches are used

as generic switches, all LEDS can be programmed for ON,

OFF or FLASHING.

DAC-NET

DAC-NET — Digital Audio Card

Model DAC-NET provides the audio source for the FireFinder

XLS Voice Evacuation System, as well as D-NET network

communication to and from Model PMI and between

enclosures. Model DAC-NET is able to transmit eight (8)

digital channels of audio, via two (2) pairs of wire.

One (1) Model DAC-NET is required in each XLS Voice

enclosure. A maximum of 32 Model DAC-NET cards are

allowed on a single XLS FireFinder system. Model

DAC-NET can be wired ‘Class A’ (Style 7) (four [4] pairs

of wires) or ‘Class B’ (Style 4) (two [2] pairs of wires).

Model DAC-NET card plugs into one (1) slot in the Model

CC-5 or CC-2 card cage, and has on-board LEDs for

system status and troubleshooting.

Indication of power, communication, internal operation,

ground fault, and trouble conditions are provided.

Model DAC-NET Card contains an on-board

microprocessor that provides communication with switch

modules, LED modules, microphone, telephone zone

cards, and zone amplifiers across the Control Area

Network CAN Bus.

Model DAC-NET can supervise up to 99 CAN address

modules, and contains on-board tones and pre-recorded

EVAC and ALERT messages. In addition, custom mes-

sages or tones can be downloaded to the DAC-NET using

the XLS software tool, ZEUS, for a total of five (5) minutes

of storage memory.

LPB

LPB — Local Page Board

The Local Page Board (Model LPB) is used to connect the

microphone ─ mounted inside the Live Voice Module (Model

LVM) ─ and the voice-internal telephone system. Model LPB

is a plug-on board to Model DAC-NET, and converts the two

(2) analog input signals into the system’s internal digital

format.

Up to five (5) Model LVMs can be connected to Model LPB.

Additionally, Model LPB provides one (1) analog output to

connect to the monitor speaker, which is mounted inside

Model LVM. The one (1) analog output is one (1) of eight (8)

voice-internal audio channels selectable at the XLSV fire-alarm

panel.

ZAC-40

ZAC-40 — Zone Amplifier Card (40 Watt)

Model ZAC-40 is a combination 40-Watt, amplifier /

speaker zone for use with FireFinder XLS. Style Y, Z or

"A / B" speaker-zone wiring configurations are supported.

Model ZAC-40 is power limited, and can be configured to

provide 40 Watts of audio at 25VRMS or 70VRMS. Model

ZAC-40 is a plug-in card that mounts in a Model CC-5 or

CC-2 card cage.

Model ZAC-40 is capable of amplifying any of the eight

(8) digital audio channels that are transmitted from Model

DAC-NET, via the digital audio bus: Model ASI (Audio

Serial Interface).

Model ZAC-40 is supervised for functionality, and provides

a single, 40-Watt speaker zone that supports two (2)

speaker circuits. Model ZAC-40 can be used for (1) one-to-

eight (8) channel applications, or as a bulk amplifier for (1)

one-or-two (2) channel applications

─ feeding high-level

audio to Models ZIC-4A and ZIC-8B. Model ZAC-40 can also

be used for single-channel applications feeding high-level

audio to Model HCP.

1 2 3 4 5 6

Comentarios a estos manuales

Sin comentarios

Siemens FIREFINDER-XLS Manual de usuario Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens FIREFINDER-XLS