Siemens SIMATIC NET PROFIBUS Instrucciones de operaciones Pagina 453

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 490
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 452
Installation and Startup
5-3
PROFIBUS Optical Bus Terminal (OBT)
C79000-G8976-C122-02
5.2 Installation
Installing the PROFIBUS OBT
PROFIBUS OBT can be installed either on a 35 mm standard rail with a height of
15 mm in compliance with DIN EN 50 022 35 x 15 or directly on a level surface.
S Select the installation location so that the climatic limit values listed in the
technical specifications can be adhered to.
S Make sure there is enough space for connecting the bus and power supply
cables.
S Install the modules only on a low-resistance and low-inductance grounded
standard rail or mounting plate. If you secure the modules on a mounting plate,
make sure that as short a cable as possible leads from the ground terminal of
the OBT to the nearest possible ground point.
Installation on a Standard rail
S Fit the upper catch of the module onto the standard rail and push in the lower
part of the module as shown in Figure 5-1 until it audibly clicks into position.
S The module is removed by pulling down the locking bar.
Figure 5-1 Installation of a Module on a Standard Rail
Vista de pagina 452
1 2 ... 448 449 450 451 452 453 454 455 456 457 458 ... 489 490

Comentarios a estos manuales

Sin comentarios