Siemens 2602 Guía de usuario descargar pdf (Pagina 30)

B-1

Appendix B

ABLES

Ethernet Cable

Cable Types and Specifications

Table B-1. Cable Types and Specifications

Twisted-pair Cable

Caution: DO NOT plug a phone jack connector into any RJ-45 port. Use only twisted-pair cables with

RJ-45 connectors that conform with FCC standards.

For 10BASE-T/100BASE-TX connections, a twisted-pair cable must have two pairs of wires. Each wire

pair is identified by two different colors. An RJ-45 connector must be attached to both ends of the cable.

Except for the WAN port, all RJ-45 ports on the SpeedStream 2602 support automatic MDI/MDI-X

configuration, so you can use straight-through cable to attach the LAN ports to any network device.

However, when connecting the WAN port to a broadband modem, you will need to use either straight-

through or crossover cable, depending on the port type used on the modem.

The figure below illustrates how the pin numbering on the RJ-45 connector. Be sure to hold the connectors

in the same orientation when attaching the wires to the pins.

Figure B-1. RJ-45 Pin Numbering

Cable Type Max. Length Connector

10BASE-T Cat. 3, 4, 5 100-ohm UTP 100 m (328 ft) RJ-45

100BASE-TX Cat. 5 100-ohm UTP 100 m (328 ft) RJ-45

1 2 ... 25 26 27 28 29 30 31 32

Sin comentarios

Siemens 2602 Guía de usuario Pagina 30